Configuring the RiskVision Host Settings

If you installed the connector on the same host as RiskVision, the connector will automatically display on the Administration > Connectors page. By default, the connector uses loopback (localhost) on port 443 to communicate with the RiskVision server. When you install the connector on a different host or use a port other than 443, you must configure the RiskVision application host information. GS: The below instructions were copied from the Exploit Database connector guide, due to their similarity. Let me know if any step of these are wrong.

To change the RiskVision host settings:

1. Open the /NVD Connector/cfg/connector.properties file in the connector host.

2. Point the server_host property to the RiskVision host name or IP adress.

3. Save the file.

4. Restart the connector service.