Configuring the RiskVision Host Settings

If you installed the connector on the same host as RiskVision, the connector will automatically display on the Administration > Connectors page. By default, the connector uses loopback (localhost) on port 443 to communicate with the RiskVision server. When you install the connector on a different host or use a port other than 443, you must configure the RiskVision application host information.

To change the RiskVision host settings:

1. Open the /Exploit Database Connector/cfg/connector.properties file in the connector host.

2. Point the server_host property to the RiskVision host name or IP adress.

3. Save the file.

4. Restart the connector service.